We love to see our products being installed and used on customer cars. Race car driver and restoration specialist Jim Froula of Racecraft is running our latest ZCG Heat Shield in his vintage 260z race car!

A few close-ups of the ZCG Heat Shield, this piece is serial #0025:

A short background on this 1973 Datsun 260Z from Jim:

“This car was built in the winter of ’77-’78 and its first event was the Portland Rose Cup in June 1978. The Portland Rose Festival’s queen, Tina Klassy, was photographed with the car and featured in local advertising for the event. The car competed in SCCA CP class mainly in events on the west coast and ran in the SCCA National Runoffs twice with sponsorship help from Carlos Vercelli, owner of well known Datsun specialty service shop “Carlos Garage” in Fullerton, CA . It was campaigned successfully at a national level, including a 3rd place finish at the SCCA runoff’s. Survived in its original production class specification and bodywork throughout the entire time. It received a cosmetic restoration in 2015 and was put back into its original Carlos’s Garage livery and currently runs vintage events across the country today.”

At the 2018 RMMR we were happy to see Carlos Vercelli (red hat) supporting the Z with driver John Murray:

The ZCG Heat Shield is available for purchase at $169.00 with product information below.  View this product and other ZCG parts on the new “products” page of our website HERE

ZCG Heat Shield

 

We are excited to offer the Z Car Garage Heat Shield for your triple-carb’d L-series Z car. This is a one-piece 304 stainless unit with laser-etched serial number. Proven on all of our L-series engine builds and dyno testing.

This heat shield will fit Mikuni, Weber, Dellorto and Jenvey induction with several intake manifolds like the Harada:

Jim Froula also runs our Z Car Garage CV axles on several of his vintage race cars, check it out!

Z Car Garage CV Axles

Over 85 sets of ZCG CV Axles sold!

Race car driver and restoration specialist Jim Froula of Racecraft is running ZCG axles in several of his cars:

Set #246 – installed May 2018 on the “Harry Stewart #52” Datsun 510:

 

Set #247 – installed April 2018 on the 260z

 

Set #248 – installed on Adam Carolla’s “Greg Sorrentino #90” Datsun 510.

We are pleased to report that Jim will also be installing a set on his “George Alderman #32” 300ZX! The ZCG CV axles are also perfect for high hp street cars which can be seen in the link above.

Z Car Garage Big-Brake Kit

Our ZCG Big-Brake kit is the last stop in braking performance for your S30.

ZCG Big-brakes and T3 coil-overs replacing stock setup on Brian’s 1973 240z:

   

View these products on the new “products” page of our website HERE, stay tuned for more innovative parts from Z Car Garage!